Cheek cheekbone filler application, There are standard aesthetic measurements for a young and beautiful appearance on the face. In general, there are common features in all faces that are accepted as beautiful. A protruding cheekbone, a prominent jawline, a triangular face appearance presents an ideal face format. However, these norms do not apply to everyone due to aging or personal characteristics. Among these areas, especially the cheekbone area and cheeks are very important. Because the volume of the cheekbone area decreases due to aging. Tissue accumulation on the smile lines increases and the smile lines deepen. In addition, noticeable hollows occur in the cheek area in thin patients. This appearance makes the person look older and paler than they are.
Fat injection can be applied to fill these areas. However, the best method without surgery is face-ready filler applications. The filler applied to the cheekbone both creates fullness in that area. It also provides a lifting effect on the face and recovery. The filler applied to the cheeks reduces skin depressions and wrinkles, allowing that area to have a better appearance. In this way, the distorted face oval is regained with a triangular appearance.
The filler should be applied especially after a good analysis of the face, and although the patients’ expectations are reduced, the areas of the face that need filler should be specified. In fact, a drawing should definitely be made on the patient’s face and it should be determined in advance how much volume will be given to which area.
Cheek fillers are usually applied to patients with very thin faces or those who have recently lost a lot of weight. Cheekbone fillers are applied to patients who do not have enough volume in the malar region due to either structural or aging reasons. Sometimes these areas are related to each other. Applying to both areas at the same time provides a better facial harmony and softens the malar-cheek transition.
The dose to be applied varies according to the desired volume on the face and the volume loss that occurs. The application is made to the deep layer or even directly on the bone. Using a cannula is a better option. Generally, 0.5-2 cc filler application for each area in the cheekbone area gives satisfactory results. 0.5-2 cc application is sufficient for the cheek area. The preferred filler is Voluma. It provides a good volumetric gain. Alternatively, Radiesse can be used. Permanence varies between 1 and 2 years.
The filler applied to the cheek and cheekbone area should be done in a natural and aesthetic way to restore the lost volumes and restore the proportional harmony of the face. Avoiding unnatural and exaggerated applications is very important for the validity of the application. Because an artificial and exaggerated facial appearance that has lost its naturalness will not be found pleasant by anyone. The aim of these applications is to contribute to the pleasant appearance of the face with small touches. If the volume loss on the face is very high, filler applications should be done either in stages or fat injection should be considered.